Note
The pole diameter must be between 40 to 70 mm (1.6 to 2.8 inches). Position the cellular AP on the pole at least 120 cm (47 in) up from the base of the pole.
Loosen the four nuts of the assembled bracket. Slide the two clamps to the left, and then rotate them out of the way.
Attach the bracket to the pole at the proper height. Fit the threaded bolts of the bracket to either side of the pole, and then turn the clamps to the proper position. Fasten all four nuts tightly.
Align the pin on the cellular AP bracket to the pin holes on the pole bracket, and then lower the pin into the pin holes vertically until the hooks on the cellular AP slides firmly into the slots on the pole bracket.
Tighten the screw on the top of the bracket using a Phillips screwdriver to complete the installation.