The AP can be installed on wall or ceiling using the included mounting bracket.
Mounting on a Wall
At the installation location on the wall, use the metal mounting bracket as a guide to mark four holes for the wall plugs and screws (included in the screw kit).
Drill four holes for the anchors, and then insert the anchors. Use a mallet or small hammer to carefully drive the anchors flush with the wall surface. Use the four screws to secure the bracket to the wall.
Note
Drill 2.5 mm (±0.2 mm) holes for M3 self-tapping screws (when not using anchors), or 4.5 mm (±0.2 mm) holes for the nylon wall anchors.
With its ports facing down, place the AP2600 access point over the bracket flanges and then slide it down until it snaps into its secured position.
Mounting on a Ceiling
At the installation location on the ceiling, use the metal mounting bracket as a guide to mark four holes for the anchors and screws (included in the box). The mounting bracket is not intended for use with drop ceiling T-bars.
Drill four holes for the anchors, and then insert the anchors. Use a mallet or small hammer to carefully drive the anchors flush with the ceiling surface. Use the four screws to secure the bracket to the ceiling (screw torque must be less than 6 kgf.cm or .6 Nm).
Note
Drill 2.5 mm (±0.2 mm) holes for M3 self-tapping screws (when not using anchors), or 4.5 mm (±0.2 mm) holes for the nylon wall anchors.
Place the AP2600 access point over the bracket flanges and then slide it onto the bracket until it snaps into its secured position.