Configure the Default Traffic Direction - Configuring-NetCloud-Exchange-Secure-Connect/Configure-the-Default-Traffic-Direction

Secure Connect Configuration Guide

ft:locale
en-US
ft:sourceName
Paligo_Prod
Document Type
Configuration Guide

Default behavior is for traffic to flow through the tunnel and egress out either through the External Resources (Untrusted) interface for the public internet or the Internal Resources (Trusted) interface for internal resources. By changing the default traffic direction to Internal Resources (Trusted), traffic is sent through the trusted network before egressing out to the internet.

Note

Minimum software version required to select the default traffic direction is 7.24.100.

Complete the following steps to configure the default traffic direction:

  1. Log into Ericsson NetCloud Manager.

  2. Select Networks in the left-side navigation panel.

  3. Select the Secure Connect network's tile.

  4. Select Network Configuration in the top-right corner of the page.

    Network Configuration button on the NetCloud Manager Networks page.
  5. Select the Configuration tab.

  6. Select the Routing tab.

  7. Select the General tab.

  8. Optional: Check the Disable NAT on Egress Interface to preserve the original IP addresses for egress interface traffic.

  9. Select the path by which egress interface traffic is directed in the Default Traffic Direction drop-down menu.

    Configuration Routing page showing the Default Traffic Direction options.
    • External Resources (Untrusted) – Default setting. Traffic egresses the wan0 interface when resolving to external resources.

    • Internal Resources (Trusted) – Traffic egresses the lan0 interface when resolving to external resources.

      This option is used to route internet traffic not defined as any resource through a next-hop on the lan0 interface, such as a firewall, before going out to the internet. This feature does not change the requirement for destinations on lan0 to have a resource and access policy defined to prevent unauthorized access to destinations on the lan0 interface.

      Complete the following steps if Internal Resources (Trusted) is selected:

      1. Enter the Primary Gateway Next-Hop Address.

        Default Traffic Direction section of Routing page highlighting the Primary Gateway Next-Hop Address field.
      2. Optional: Enter the Secondary Gateway Next-Hop Address.

        Note

        Select the Use the same address for the Secondary Service Gateway checkbox to use only one IP address for both service gateways.

      3. Select Save.

  10. Select Save.