Connecting the Power Source - Cradlepoint-R1900-Mobile-Router-Vehicle-Installation-Guide/Connecting-the-Power-Source

Vehicle Installation Guide for Cradlepoint R1900 Mobile Router

ft:locale
en-US
ft:sourceName
Paligo_Prod

The router includes a three-meter, 22 AWG four-pin power connector. The following diagram shows the connector pinout on the router.

Diagram

PIN

Wire Color

Definition

Details

image2.png

1

Black

Ground

Ground to the vehicle chassis

2

Red

Power

VDC battery constant

3

Orange

Input

VDC ignition sensing accessory input

4

Blue

Output

General purpose I/O (GPIO)

Table 3. 4-Pin Connector Layout.

Note

Cradlepoint uses a unique pin layout, which may differ from other industry standards.

image3.png
  1. Connect the red wire (power) to the battery positive and the black wire to ground. If the power is connected correctly, the LED lights will light up on the router.

  2. If using Ignition Sensing, connect the orange wire (input) to the ignition (or accessory) switch. The input wire may be attached directly or through the fuse panel. Refer to the image below for a wiring example.

    image4.jpeg

Cradlepoint strongly recommends configuring ignition sensing to enable the router to detect when the vehicle’s ignition is turned off and then safely shuts down after the router completes the process of writing to its memory, such as during a firmware upgrade or routine network update.