(OPTIONAL) Connect a 6-pin GPIO power connector to the RX30 - Cradlepoint-R1900-Mobile-Router-Vehicle-Installation-Guide/OPTIONAL-Connect-a-6-pin-GPIO-power-connector-to-the-RX30

Vehicle Installation Guide for Cradlepoint R1900 Mobile Router

ft:locale
en-US
ft:sourceName
Paligo_Prod

The 6-pin GPIO and power cable (shipped with the RX30) provides power to both the RX30 managed accessory and the R1900 router attached to it.

The purpose of this configuration is to allow for using a 6-wire/GPIO cable to hardwire power for DC connections or use GPIO.

Refer to the following for pin configuration:

Diagram

PIN

Wire Color

Definition

6pin_GPIO_Connector_Diagram.png

1

Red

Power (9-36 VDC)

2

Black

Ground

3

Orange

Digital Input/Ignition Sense

4

Red

Power (9-36 VDC)

5

Black

Ground

6

Blue

Digital Output

  1. Insert the 6-pin end of the power adapter into the 6-pin port on the RX30, ensuring appropriate alignment of pins as illustrated above.

  2. Connect the wires on the other end to the appropriate fuse or power source.

    Note

    Both sets of red and black wires (connector pins 1, 2, 4, and 5) must be connected to the power source due to the RX30 managed accessory’s max power draw specification.

  3. Allow the endpoint to run through its bootup sequence.

    Note

    The LEDs on the R1900 will flash during bootup.

Warning

If the router is shut off during an upgrade/update, permanent damage to the router may occur.

Refer to Getting Started with Ignition Sensing, for the steps to configure ignition sensing.