Creating New WAN VLANs for Control Messages - Cradlepoint-Wi-Fi-Collection/Creating-New-WAN-VLANs-for-Control-Messages

Managing Wi-Fi with NetCloud Manager

NetCloud Feature
Networking
Networking > Wireless LAN
ft:locale
en-US
ft:sourceName
Paligo_Prod
Document Type
Admin Guide

This VLAN logically encapsulates the transport layer, allowing the Controller to capture the Captive router and configure it.

  1. Log into NetCloud Manager.

  2. Click Devices in the left-side navigation panel.

  3. Select the Controller router.

  4. Select the Remote Connect menu and then select Device UI.

  5. Navigate to NETWORKNG > VLAN Interfaces.

  6. Select Add to open the VLAN configuration dialog.

  7. Add a new VLAN with the following properties:

    • VID: Set this to any unique VID the administrator wants to use.

    • Name (UID): Use "CAPTIVE-WIFI". This name is required for this VLAN.

      Tip

      Selecting the Captive Wifi checkbox on this dialog autofills the correct UID.

      CAPTIVE-WIFI.png

      Warning

      Use "CAPTIVE-WIFI" exactly for the VLAN's name. NetCloud OS uses this value to identify which VLAN to use for the Captive Wi-Fi data transport.

    • Mode: Select WAN from the drop-down list. Using WAN mode allows the feature to use the VLAN as either a WAN or a LAN, depending on the network configuration used.

    • Select the Captive Wifi checkbox.

    • Add a tagged port for the VLAN:

      1. Click Add in the Configured Ports section.

      2. Select Port 4(Ethernet 4) in the Port column.

      3. Select Tagged in the Mode column.

      4. Click Save.

  8. Click Save to save the VLAN configuration.

  9. Add another new VLAN with the following properties:

    • VID: Set this to any unique VID the administrator wants to use.

    • Name: CAPWIFI-CONTROL is used in this example, but a specific name is not required for this VLAN.

      CAPWIFI-CONTROL.png
    • Mode: Select WAN from the drop-down list. Using WAN mode allows the feature to use the VLAN as either a WAN or a LAN, depending on the network configuration used.

    • Leave the Captive Wifi checkbox unselected.

    • Add an untagged port for the VLAN:

      1. Click Add in the Configured Ports section.

      2. Select Port 4(Ethernet 4) in the Port column.

      3. Select Untagged in the Mode column.

      4. Click Save.

  10. Select Save. It may take several seconds for the changes to be saved and activated on the router.

    save-captive-wif-control.png