Complete the following to configure a route policy:
Log into NetCloud Manager.
Select in the left-side navigation panel.
Select a router from the Routers page. Alternatively, to make configuration changes to a group, navigate to the Groups page and select a group.
Select and then .
Navigate to > > .
Under Route Policies, select .
From the Route Policy Editor dialog, configure the policy:
Type – Select the type of policy. Use Disabled to ignore this policy, or specify the IP protocol version that this policy will match, or select Service for a policy to be handled by another service.
A service policy may be used by a router service (such as NEMO) to prioritize automatically created policies. To assign a service policy to a service, the route table created for that service must also be selected below. A service policy not needed by or not assigned to an operating service will be ignored.
Source IP/Network Address – Select the source IP network upon which this policy will match. Leave blank to match on any.
Destination IP/Network Address – Select the destination IP network upon which this policy will match. Leave blank to match on any.
Incoming Device – Select the incoming device upon which this policy will match. Leave blank to match on any. 'lo' is a special device that matches all local (router-originated) traffic, including Network Time Protocol, Syslog, TACACS, NetCloud, and updates. 'lo:nc' matches just the subset of local traffic for NetCloud. 'lo:updates' matches just the subset of local traffic for updates downloaded directly from content delivery networks such as modem and router firmware and IPS signatures. 'lo:security' matches a subset of local traffic used for security services such as Webroot. To route local traffic differently than either subset, policy for the subset(s) should be configured with a higher priority than the more general local source.
Table – Select the route table to use for routing when this policy is matched.
Select .