Configuring Network Time Protocol (NTP) - Netcloud-Manager-Policy-Routes/Configuring-Network-Time-Protocol-NTP

Navigate to NETWORKING > Local Networks > Local IP Networks.

Create a new LAN. For additional help creating a LAN, see How to add a loopback Interface.

Assign a new IP with a /32 subnet mask in the IP Address field.

Select "Loopback" from the IPv4 Routing Mode drop-down menu.

Navigate to SYSTEM > Administration > Router Services.

Create a LAN network binding for NTP to the Loopback LAN. For additional information on how to create a LAN binding, see How to Configure Router Services with LAN Network Binding.

Navigate to NETWORKING > Routing > Static and Policy Routing.

Create a Route Policy using the steps in Policy Based Routing.

Add the loopback IP address in the Source IP/Network Address field.

Select "lo (Local router-originated)" from the Incoming Device drop-down menu.

In the Reference section, select "NCM" from the Table drop-down menu.

Move this policy above the default "any, any" policy.