Install the Wall/Pole Mount - R920 - RX20 - W1855 - W1855-Series-5G-Wideband-Adapter-Installation-Guide/Install-the-Wall/Pole-Mount

Cradlepoint W1855 Series 5G Wideband Adapter Installation Guide

ft:locale
en-US
ft:sourceName
Paligo_Prod
Document Type
Quick Start Guide

At this point you are ready to travel to the adapter's final installation site to install the wall/pole mount followed by the adapterassembly. Gather the tools you will need (depending on your chosen mounting method), the adapter assembly, and the wall/pole mount (and associated screws and anchors, or pole clamps) before leaving.

There are two options for installing the wall/pole mount:

Pole mounting
  1. Using a flathead screwdriver (or socket driver), open the pole clamps. When the ends separate, insert each clamp through the appropriate slots in the wall/pole mount.

    Note

    You can install the pole clamps on the wall/pole mount to accommodate a horizontal or vertical pole by using the appropriate slots in the wall/pole mount. When installing vertically, make sure the locking arm is pointing down and the arrow on the wall/pole mount points upward.

  2. Wrap the pole mounting clamps around the pole at the appropriate height (you may have to force each clamp wider temporarily to get them around the pole). Slide the ends of each clamp together and then tighten the clamps with a flathead screwdriver (or socket driver).

  3. Continue on to the next step, Attach Adapter Assembly to Wall/Pole Mount.

Wall mounting
  1. Hold the wall/pole mount against an outdoor wall and mark the drill holes.

    Note

    You can place the wall/pole mount either horizontally or vertically. When installing vertically, make sure the locking arm is pointing down and the arrow on the wall/pole mount is pointing upward.

  2. Place the mount aside, and then drill the holes with an appropriate drill bit (if needed, depending on the mounting surface and whether you are using wall anchors).

  3. Insert wall anchors (if needed, depending on the mounting surface).

  4. Drive four wall mount screws into the anchors (or mounting surface if no wall anchors are needed) but leave a short length of each screw protruding.

  5. Hang the mount on the screws and then slide the mount so the narrow portion of the keyholes engage the mounting screws.

  6. Tighten the wall mount screws the rest of the way.